Table of Contents
Advertisement
Figure 133. Removing the bottom M.2 cabled adapter
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Adjust the retainer on the M.2 adapter
Follow instructions in this section to adjust the retainer on the M.2 adapter.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
Procedure
Step 1.
Locate the retainer to be adjusted. If the retainer is secured on the M.2 adapter, loosen the screw
that secures the retainer.
Step 2.
Select the correct keyhole that can accommodate the particular size of the M.2 drive to be
installed.
Step 3.
Adjust the M.2 retainer.
a.
Press and hold both sides of the retainer.
b.
Move the retainer forward until it is in the large opening of the keyhole.
c.
Take the retainer out of the keyhole.
d.
Insert the retainer into the correct keyhole.
e.
Press and hold both sides of the retainer.
f.
Slide the retainer toward the small opening of the keyhole until it is seated in place.
ThinkEdge SE360 V2 User Guide
130
"Install the bottom M.2 cabled adapter and M.2 drives" on page
and
"Safety inspection checklist" on page 48
131.
to ensure that you
Advertisement
Table of Contents
Troubleshooting
