Table of Contents
Advertisement
Step 4.
If applicable, remove the WLAN antennas. See
Step 5.
If applicable, turn the screw between the two SMA connectors clockwise to shorten the connectors
into the chassis.
Note: Make sure that the SMA connectors are shortened into the chassis; if the SMA connectors
are extended and out of the chassis, the node can not be installed successfully.
Figure 59. Shortening the SMA connectors
Step 6.
Depending on the model, fasten four screws or thumbscrews to secure one side bracket to the
node; then, repeat the procedure to the other side bracket.
Note: There are "L" and "R" logos marked on the front of side brackets which represent the left
bracket and the right bracket (viewed from the front of the node). Make sure to install the brackets
with correct orientation shown in the illustration.
Figure 60. Installing the side brackets with screws
"Remove the WLAN antennas" on page
.
Chapter 5
Hardware replacement procedures
299.
79
Advertisement
Table of Contents
Troubleshooting
