Install the top cover
Follow instructions in this section to install the top cover.
S014
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the label is attached.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Make sure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
• Make sure that all internal cables are correctly routed. See
Procedure
Step 1.
Turn the keylock to the unlock position with the key; then, take the key out of the keylock, and
reverse the node to let the top side facing up.
Figure 207. Unlocking the keylock
Step 2.
Align the top cover with the guiding slots on both sides of the chassis; then, slide it forward until it
is firmly seated.
ThinkEdge SE360 V2 User Guide
200
and
"Safety inspection checklist" on page 48
Chapter 6 "Internal cable routing" on page
to ensure that you
327.