Cmos Battery (Cr2032) Replacement - Lenovo ThinkEdge SE360 V2 User Manual

CMOS battery (CR2032) replacement

Follow instructions in this section to remove and install a CMOS battery (CR2032).
Remove a CMOS battery (CR2032)
Follow instructions in this section to remove a CMOS battery (CR2032).
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S004
CAUTION:
When replacing the lithium battery, use only Lenovo specified part number or an equivalent type
battery recommended by the manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
S005
CAUTION:
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it
only with the approved part. Recycle or discard the battery as instructed by local regulations.
Consider the following when replacing the CMOS battery.
ThinkEdge SE360 V2 User Guide
134