Lenovo ThinkEdge SE360 V2 User Manual page 369

Note: For the detailed steps, see ThinkShield Edge Mobile Management Application User Guide in
https://lenovopress.lenovo.com/lp1725-thinkedge-security.
Connection with Bluetooth
Note: SE360 V2 comes with two Bluetooth buttons with LED, one on the front and one on the rear of the
node. To locate the Bluetooth buttons, see
panel LEDs" on page
1. Connect the power cable to your ThinkEdge SE360 V2.
2. Download the ThinkShield Edge Mobile Management App from Google Play Store or Apple App Store
to your Android or iOS based smart phone (search term: "ThinkShield Edge").
3. Make sure to turn on Bluetooth on your smart phone.
4. Press one of the Bluetooth buttons to enable Bluetooth.
Note: After the Bluetooth button is pressed, if SE360 V2 does not pair with any Bluetooth devices
within 10 minutes, Bluetooth will be disabled automatically. If necessary, press the Bluetooth button
again to enable Bluetooth.
5. Log-in to the ThinkShield Edge Mobile Management App using your Organization registered ID.
6. Follow the "Activate Device" on-screen instructions to complete secure activation of the system.
Note: For the detailed steps, see ThinkShield Edge Mobile Management Application User Guide in
https://lenovopress.lenovo.com/lp1725-thinkedge-security.
7. When activated successfully, ThinkShield Edge Mobile Management App will provide "Device
Activated" screen.
8. After the system is activated successfully, disable the Bluetooth buttons.
a. Go to Lenovo XClarity Controller web interface, and click BMC Configuration ➙ Security.
b. Click Bluetooth Button on Panel to disable the Bluetooth buttons.
• Portal automatic activation
Note: To activate the system through ThinkShield Key Vault Portal web interface for the first time, the
system should be claimed by your organization. Machine Type, Serial Number, and Activation Code are
required to claim a device. For more information of claiming the device, see
com/lp1725-thinkedge-security.
1. Connect the power cable to your ThinkEdge SE360 V2.
2. Connect the XClarity Controller Management Ethernet port to a network that has access to the
internet.
Note: Outbound TCP port 443 (HTTPS) must be open for activation to occur.
3. Log in to the ThinkShield Key Vault Portal with your Organization registered ID.
4. If the server is not claimed by your organization, claim the server. Add the device by clicking the
Claim device button in Device Manager. Enter machine type, serial number, and secure activation
code in the corresponding fields.
5. From the Device Manager, select the server you plan to activate and click activate. The status of the
server will change to Ready.
6. Server will be activated within 15 minutes and power on automatically. After successful activation, the
status of the server will change to Active on the ThinkShield Key Vault Portal.
Notes:
– If the server activation is not initiated within 2 hours after the power cable plug in, perform a disconnect
then re-connect of the power cable to your ThinkEdge SE360 V2.
"Front operator panel LEDs" on page 373
376.
and "Rear operator
https://lenovopress.lenovo.
.
Chapter 7 System configuration
359