Intrusion Switch With Cable Replacement - Lenovo ThinkEdge SE360 V2 User Manual

Intrusion switch with cable replacement

Follow instructions in this section to remove and install the intrusion switch with cable.
Remove the top intrusion switch with cable
Follow instructions in this section to remove the top intrusion switch with cable.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove the PMB air baffle. See
c. Lift the riser assembly from the node. See
228.
d. Remove the processor air baffle. See
board" on page
Step 2. Disconnect the intrusion switch cable from the system board.
and "Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the processor air baffle and air flow sensor
110.
197.
"Remove the riser assembly from the node" on page
.
Chapter 5 Hardware replacement procedures
to ensure that you
107.
159