Table of Contents
Advertisement
b.
Connect the signal cable to
c.
Connect the signal cable to
Step 2.
Reinstall the processor air baffle. See
page
114.
Note: Make sure to adjust the processor air baffle according to the configuration.
For the configuration with full-height PCIe adapter
Step 3.
Align the front of the riser assembly with the edge of the chassis; then, lower the riser assembly to
the node.
Figure 286. Lowering the riser assembly
Step 4.
Route the cables between the riser cage and the processor air baffle.
a.
Push the cables toward the riser cage until the cables are seated in the notch of riser cage.
b.
Push the rubber part of processor air baffle to bend it until it is against the cables.
PCIe Gen 4 MCIO 1 connector on the system board.
2a
PCIe Gen 4 MCIO 2 connector on the system board.
2b
"Install the processor air baffle and air flow sensor board" on
For the configuration without full-height PCIe
adapter
Chapter 5
.
Hardware replacement procedures
267
Advertisement
Table of Contents
Troubleshooting
