Lenovo ThinkEdge SE360 V2 User Manual page 55

Typically, you will need to connect the following cables:
• Connect server to the power source
Note: If applicable, before connecting DC power source to the server, remove the header from the
corresponding power connector. See
remove the header.
• Connect server to the data network
• Connect the server to the storage device
• Connect the server to the management network
6. For the models without wireless module, install the Bluetooth antenna filler to the corresponding slot for
proper operation. The Bluetooth antenna filler is in the material box. See
locate the Bluetooth antenna filler.
7. Install the I/O fillers when the connectors are not used. The connectors could be damaged without
proper protection of the fillers. The I/O fillers are in the material box. See
and "Rear I/O filler" on page 26
8. If the security LED of the server is blinking, the server is in System Lockdown Mode. Activate or unlock
the system for operation. See
9. Power on the server.
Power button location and power LED are specified in:
• Chapter 2 "Server components" on page 19
• "Troubleshooting by system LEDs" on page 373
The server can be turned on (power LED on) in any of the following ways:
• You can press the power button.
• The server can restart automatically after a power interruption.
• The server can respond to remote power-on requests sent to the Lenovo XClarity Controller.
Note: You can access the management processor interface to configure the system without powering
on the server. Whenever the server is connected to power, the management processor interface is
available. For details about accessing the management server processor, see "Opening and Using the
XClarity Controller Web Interface" section in the XCC documentation compatible with your server at
https://pubs.lenovo.com/lxcc-overview/
10. Validate the server. Make sure that the power LED, Ethernet connector LED, and network LED are lit with
green light, which means the server hardware was set up successfully.
See "System LEDs" on page 34
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
•
https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
"Rear view" on page 23
to distinguish the I/O fillers.
"Activate or unlock the system" on page
.
for more information on the LED indications.
349.
to locate the power connector and
"Front view" on page 19
"Front I/O fillers" on page 22
357.
.
Chapter 4 Unboxing and setup
to
Chapter 7
45