Table of Contents
Advertisement
Watch the procedure on YouTube
M.2 heat sink replacement
Follow instructions in this section to remove and install an M.2 heat sink.
Remove an M.2 heat sink
Follow instructions in this section to remove an M.2 heat sink.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
Procedure
Step 1.
Push the tabs on the heat-sink tray to disengage the M.2 heat sink.
Note: If necessary, push the tabs with a flat-head screwdriver.
Step 2.
Lift the M.2 heat sink from the tray.
Step 3.
Slide the M.2 drive outward to remove it from the tray.
Figure 193. Removing the M.2 heat sink
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install an M.2 heat sink
Follow instructions in this section to install an M.2 heat sink.
About this task
Attention:
and
"Safety inspection checklist" on page 48
"Install an M.2 heat sink" on page
185.
.
Chapter 5
Hardware replacement procedures
to ensure that you
185
Advertisement
Table of Contents
Troubleshooting
