Complete The Parts Replacement - Lenovo ThinkEdge SE360 V2 User Manual

Minimal requirement
Keep two WLAN antennas away from each other at an
angle not less than 90° to avoid signal interference.
• Complete the parts replacement. See

Complete the parts replacement

Go through the checklist to complete parts replacement
To complete the parts replacement, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside your server.
2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
3. Reinstall the air baffles. See
Note: For proper cooling and airflow, reinstall the air baffle before powering on the server. Operating the
server with the air baffle removed might damage server components.
4. Reinstall the top cover. See
5. Reinstall the bottom cover. See
6. If necessary, reinstall the node to the enclosure or mount. See
7. Reconnect the power cords and any cables that you removed.
8. Install the I/O fillers when the connectors are not used. The connectors could be damaged without
proper protection of the fillers. See
9. If applicable, install the header when the power connector is not used. The connector could be damaged
without proper protection.
a. Locate the power connector. See
b. Insert the header to the power connector which is not used.
c. Fasten two captive screws to secure the header.
ThinkEdge SE360 V2 User Guide
324
"Complete the parts replacement" on page
"Air baffle and air flow sensor board replacement" on page
"Install the top cover" on page
"Install the bottom cover" on page
"Front I/O fillers" on page 22
"Rear view" on page
Recommended angle
For better performance, adjust the antennas away from
the chassis at a 45° angle.
200.
203.
"Configuration guide" on page
and "Rear I/O filler" on page
23.
324.
105.
54.
26.