Mechanical Installation; Items Supplied; Transport; Inspection On Receipt - Danfoss VLT ISD 511 Operating Manual

VLT® Servo Drive System ISD 511
Operating Guide

4 Mechanical Installation

4.1 Items Supplied

The items supplied for the ISD 511 servo system are:
• ISD 511 servo drives
• Power Supply Module (PSM 510) including connectors
• Decentral Access Module (DAM 510) including connectors
• Auxiliary Capacitors Module (ACM 510) including connectors, optional
• Expansion Module (EXM 510), optional
• Local control panel (LCP), optional
• LCP cable, optional
• Blind caps for M23 connectors
• Flange protection cap
• This operating guide
Save the product packaging for use in the event of product return.

4.2 Transport

• Always use means of transport and lifting gear with sufficient load capacity to transport the servo system components.
• Avoid vibration during transport.
• Avoid heavy impacts and blows.

4.3 Inspection on Receipt

Procedure
1.
After receiving the delivery, immediately check whether the items supplied match the shipping documents. Danfoss does
not honor claims for faults registered later.
2. Register a complaint immediately with the carrier if there is visible transport damage.
3. Register a complaint immediately with the responsible Danfoss representative if there are visible defects or the delivery is
incomplete.

4.4 Safety Measures during Installation

Always observe the safety instructions in this manual during installation. Pay particular attention to ensuring that the following
points are always observed:
• Installation may only be performed by qualified personnel.
• Installation must be performed with due care and attention.
• All safety regulations and protective measures must be complied with, and the environmental conditions must be observed.
• The manual is read and understood.

4.5 Installation Environment

4.5.1 Overview

The installation must provide the following environmental conditions to allow the ISD 511 system to be operated safely and effi-
ciently.
Contact Danfoss if it is not possible to comply with these environmental conditions.

4.5.2 ISD 511 Servo Drive

• The allowable operating ambient temperature range, humidity, and vibration levels must not be exceeded (see
Servo Drives).
• Unrestricted ventilation must be available.
• The mounting structure must be suitable for the application, for example, adequately rigid and able to cope with temperatures
over 90 °C.
34 | Danfoss A/S © 2023.08
Mechanical Installation
11.8.1 ISD 511
AQ377148425069en-000101 / 130R1213