Show Diffserv Service - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
Non-Conform
COS
Non-Conform
DSCP Value
Non-Conform IP
Precedence
Value
Policing Style
Redirect
If the Policy Name is not specified this command displays a list of all defined DiffServ
policies. The following fields are displayed:
Policy Name
Policy Type
Class Members

13.6.4 show diffserv service

This command displays policy service information for the specified interface and
direction. The
Format
Mode
DiffServ Admin
Mode
Interface
Direction
Quality of Service (QoS) Commands
This field displays the CoS mark value if the non-conform
action is set-cos-transmit.
This field displays the DSCP mark value if the non-conform
action is set-dscp-transmit.
This field displays the IP Precedence mark value if the non-
conform action is set-prec-transmit.
This field denotes the style of policing, if any, used (simple).
Forces a classified traffic stream to a specified egress port
(physical port). This can occur in addition to any marking or
policing action. It may also be specified along with a QoS
queue assignment.
The name of this policy. (The order in which the policies are
displayed is not necessarily the same order in which they
were created.)
The policy type (Only inbound is supported).
List of all class names associated with this policy.
parameter specifies a valid slot/port number for the system.
<slot/port>
show diffserv service <slot/port> in
Privileged EXEC
The current setting of the DiffServ administrative mode. An
attached policy is only in effect on an interface while Diff-
Serv is in an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
v1.0, November 2007
13-29