Configure Private-VLAN Port Mode (Promiscuous, Host)
The example is shown as CLI commands and as a web interface procedure.
CLI: Configure Private-VLAN Port Mode (Promiscuous, Host)
Use the following commands to assign port 1/0/1 to promiscuous port mode and ports
1/0/2-1/0/5 to host port mode.
(Netgear Switch)
(Netgear Switch)
(Netgear Switch)
(Netgear Switch)
(Netgear Switch)
(Netgear Switch)
(Netgear Switch)
Web Interface: Configure Private-VLAN Port Mode
(Promiscuous, Host)
1.
Configure port 1/0/1 to promiscuous port mode.
a. Select Security > Traffic Control > Private VLAN > Private VLAN Port Mode
Configuration.
A screen similar to the following displays.
b. Under Private VLAN Port Mode Configuration, select the 1/0/1 interface check
box.
Now 1/0/1 appears in the Interface field at the top.
c. In the Port VLAN Mode field, select Promiscuous from the menu.
Managed Switches
#config
(Config)#interface 1/0/1
(Interface 1/0/1)#switchport mode private-vlan promiscuous
(Interface 1/0/1)#exit
(Config)#interface 1/0/2-1/0/5
(Interface 1/0/2-1/0/5)#switchport mode private-vlan host
(Interface 1/0/2-1/0/5)#end
VLANs
57