Advertisement
Chapter 1: Introduction
Warning
To verify proper function of indicators, they light when the system is powered on.
Portable Patient Monitor will provide you with the following vital signs data:
ECG
Heart Rate (HR), ST segment, PVCs/min, Arrhythmias, ECG waveforms
Respiratory Rate (RR) , Respiration Waveform
RESP
SpO2
Saturation pulse oximetery (SpO2), Pulse Rate (PR),SpO2 Plethysmogram
If MASIMO Rainbow* module is used, the following parameters will be
measurable:
Note:
Each of the below parameters can be used only if its software is enabled by the
manufacturer and its specific probe is available.
Arterial pulse signal strength (PI)
Total amount of hemoglobin in the blood (SpHb)
Oxygen content in the blood (SpOC)
Carboxyhemoglobin saturation percent in the blood (SpCO)
Methemoglobin saturation percent in the blood (SpMet)
Index for PI changes that occur during the respiratory cycle (PVI)
NIBP
Systolic pressure(SYS), Diastolic pressure (DIA), Mean arterial pressure (MAP)
TEMP
Channel-1 temperature (T1), Channel-2 temperature (T2)
IBP*
4-channel IBP (IBP1, IBP2, IBP3, IBP4)
EtCo2, FiCo2, AWRR
CO2*
EtN2O, FiN2O, EtO2, FiO2, EtAA, FiAA, AA is included 5 anesthesia agents
Multi-gas*
(DES, ISO, SEV, HAL and ENF)
BFA*
BFI %, BS%, SQI%, EMG%
CO*
Cardiac output
Vital signs monitor provides different functions such as visible & audible alarms, storage of
trend data, NIBP measurements and 150 arrhythmia events.
1-9
User Manual
Advertisement
Chapters
