Rep 10.5 Fuser Assembly Components - Xerox WorkCentre 4150 Service Manual

REP 10.5 Fuser Assembly Components

Parts List on PL 10.10, PL 10.25 and PL 10.26
Purpose
This procedure is used to repair the following components:
NOTE: Only perform the steps that are necessary to repair the damaged component.
• Springs, PL 10.25 Item 7.
• Carbon brush assemblies, PL 10.26 Item 7.
• Heat roller assembly, PL 10.26 Item 12.
NOTE: If a new heat roller assembly is installed, also install a new heat roller collar, PL
10.26 Item 16.
• Heat roller collar, PL 10.26 Item 16.
• Heat roller bearings, PL 10.26 Item 15.
• Pressure roller bearings, PL 10.26 Item 22.
WorkCentre 4150
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not touch the fuser while it is hot.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the fuser assembly, REP 10.1.
2. Separate the fuser assembly, Figure 1.
1
Remove 2 springs.
2
Remove the 2 screws
marked A.
Figure 1 Fuser assembly separation
September 2006
4-47
WARNING
WARNING
CAUTION
3
Carefully separate the
fuser assembly.
Repairs and Adjustments
REP 10.5