Eaton PowerXL DM1 Series Applications Manual page 190

Chapter 7- Multi-purpose application
Table 59. Outputs (Cont.).
PI supervision enable
P3.2.30 b
Minimum value: N.A.
Options: 0 = Disabled; or
1 = Enabled.
Upper and lower limits around the reference are set. When the actual value goes above or below the upper limit and lower limit, the
Description:
delay timer will increment. When the actual value is within the allowed area, the delay counter decrements. After the delay time
expires, the relay output for PI supervision will be activated. This function is used for process value out of range faults.
PI supervision display
P3.2.31 b
Minimum value: N.A.
Options: 0 = Enable DO;
1 = Warning (W/O S)/enable DO;
2 = Warning (W S)/enable DO; or
3 = Fault/enable DO.
Description: Supervision display selection.
PI supervision upper limit
P3.2.32 b
Minimum value: PI Process Unit Min
varies
Description: Upper limit for PI feedback value used with the PI supervision controller.
PI supervision lower limit
P3.2.33 b
Minimum value: PI Process Unit Min
varies
Lower limit for PI feedback value used with the PI supervision controller.
Description:
PI supervision delay
P3.2.34 b
Minimum value: 0 s
Description: Defines the delay time that the PI feedback value must be out of range before activating the PI supervision output.
P3.3 - Analog output.
AO mode
P3.3.1 b
Minimum value: N.A.
0 = 0 - 20 mA; or
Options:
1 = 0 - 10 V.
Description: Defines the analog output mode to current or voltage.
180
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Maximum value: N.A.
Maximum value: N.A.
Maximum value: PI Process Unit Max
varies
Maximum value: PI Process Unit Max
varies
Maximum value: 3,000 s
Maximum value: N.A.
ID 1346
Default value: 0
ID 1828
Default value: 0
ID 1347
Default value: 0.00 varies
ID 1349
Default value: 0.00 varies
ID 1351
Default value: 0 s
ID 227
Default value: 0