Eaton PowerXL DM1 Series Applications Manual page 143

Table 50. Serial communication (Cont.).
P11.5.4
Board status
Minimum value: N.A.
Description: Status of the board.
B0-DCOM communication fault.
B1-Board HW fault
B2-IO1 24 volt overload fault.
B3-Profibus communication fault.
B4-fieldbus fault.
P11.5.5
Firmware version
N.A.
Minimum value:
Description: This parameter provides the firmware version of the SWD.
P11.5.6
Protocol status
Minimum value: N.A.
Options: 0 = Not configured;
1 = Operational; or
2 = Diagnostics.
Description: This parameter specifies the protocol status for SWD card.
P11.6 - Bluetooth.
P11.6.1
Bluetooth enabled
N.A.
Minimum value:
Options: 0 = Disabled; or
1 = Enabled.
Description: Bluetooth enabled.
Bluetooth broadcast mode
P11.6.2 b
Minimum value: N.A.
Options: 0 = Off; or
1 = On.
Bluetooth broadcast mode.
Description:
P11.6.3
Bluetooth pairing reset
Minimum value: N.A.
Options: 0 = Not reset; or
1 = Reset.
Description: Bluetooth pairing reset.
Parameter value can only be changed after the drive has stopped.
a
Parameter value will be set to be default when changing macros.
b
Table 51. Ethernet communication (*DM1 Pro) (Cont.).
P12.1 - Basic settings (*DM1 Pro).
IP address mode
P12.1.1 a
Minimum value: N.A.
Options: 0 = Static IP; or
1 = DHCP with AutoIP.
Description: This parameter defined the IP address configuration mode for EIP/modbus TCP.
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Maximum value: N.A.
N.A.
Maximum value:
Maximum value: N.A.
N.A.
Maximum value:
Maximum value: N.A.
Maximum value: N.A.
.
Maximum value: N.A.
Chapter 6 - Pump control application
ID 2609
Default value: 0
ID 2610
N.A.
Default value:
ID 2612
Default value: 0
ID 1895
0
Default value:
ID 2920
Default value: 0
ID 2935
Default value: N.A.
ID 1500
Default value: 0
133