Eaton PowerXL DM1 Series Applications Manual page 206

Chapter 7- Multi-purpose application
Table 62. Protections (Cont.).
Underload time limit
P6.1.13 b
Minimum value: 2.00 s
Description: This time can be set between 2.00 and 600.00 seconds. This is the time allowed for an fault state to exist. An internal up/down
counter counts the accumulated underload time. If the underload counter value goes above this limit, the protection will cause a trip
according to protection parameter. If the drive is stopped, the counter is reset to zero.
Preheat mode
P6.1.14 b
Minimum value: N.A.
0 = Disable; or
Options:
1 = Enable
Description: This parameter enables/disables the preheat function where this is used where the temperature being read from the drive will turn on
the output to allow current to flow to the motor, this is typically used when the motor is not running.
Preheat control source
P6.1.15 b
N.A.
Minimum value:
Options: 0 = DI function; or
1 = Drive temperature.
Description: Selects the source of where the temperature is coming from, either digital input or the drive heat sink temperature, which potentially
could be at a different temperature.
Preheat enter temperature
P6.1.16 b
Minimum value: -10.0°C
Description: Temperature when the preheat is enabled - drive goes into a run state to all the preheat voltage to flow through the motor an create
some current.
Preheat quit temperature
P6.1.17 b
-10.0°C
Minimum value:
Description: Temperature when the preheat is disabled - drive goes into a stop state if the temperature is above this rating.
196
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Maximum value:
Time Counter
Trip Area
Underload
No Underload
Maximum value:
Maximum value:
Maximum value:
Maximum value:
600.00 s Default value:
Trip/Warning
Broken Belt
Protection
Time
N.A. Default value:
N.A.
Default value:
20.0°C Default value:
39.9°C
Default value:
ID 320
20.00 s
ID 2159
0
ID 2160
1
ID 2161
10.0°C
ID 2162
20.0°C