Eaton PowerXL DM1 Series Applications Manual page 19

Table 3. Remote keypad buttons (Cont.).
Left
Right
OK
Stop
Start
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Left arrow:
Navigation button, movement to left when editing a parameter digit by digit.
•
Backs up one step.
•
At Main Menu page by hitting Back/Reset takes the user to the Default page.
•
Right arrow:
Enter parameter group mode.
•
Enter parameter mode from group mode.
•
Enter parameter whole edit mode when this parameter can be written.
•
Enter parameter bit by bit edit mode from whole edit mode.
•
Navigation button, movement to right when editing a parameter bit by bit.
•
OK:
To clear all the Fault History if pressed for more than 5 seconds (including 5 seconds) in any page.
•
This button is used in the parameter edit mode to save the parameter setting.
•
To confirm the start-up list at the end of the Start-Up Wizard.
•
To confirm the comparison item in parameters comparison mode.
•
The following is the same with Right key:
Enter parameter whole edit mode when this parameter can be written.
•
Enter parameter group mode.
•
Enter parameter mode from group mode..
•
Stop:
This button operates as motor stop button for normal operation when the "Keypad" is selected as the control source
and keypad stop button is active, or stop button is always enabled regardless of control source.
Motor stop from the keypad.
•
Start:
This button operates as motor start button for normal operation when the "Keypad" is selected as the active control
source. When Keypad is the reference place after hitting the start button, it will jump directly to the Keypad
Ref Screen.
Chapter 2 - Keypad overview for DM1 Pro
9