Replacing Support - MacDon D65 Operator's Manual

5. Lift endshield off supports.
6. Move endshield (A) away from support (B), and place
new endshield (C) onto supports.
7. Reattach end of endshield (A) to support (B).
8. Reinstall bolts (D).
9. Tighten all hardware.

Replacing Support

DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Lower header and reel, and shut down engine. Remove key from ignition.
2. Manually rotate reel for access to endshield support (A)
to be replaced.
3. Remove bolt (B) from support (A).
4. Remove bolts (C) from support (A) and two
adjacent supports.
147725
MAINTENANCE AND SERVICING
Figure 5.191: Reel Endshields
Figure 5.192: Reel Endshields
Figure 5.193: Endshield Supports
207
Revision A