Installing Steel Tines; Removing Plastic Fingers - MacDon D65 Operator's Manual

4. Temporarily attach reel arms (B) to reel disc, using
original attachment locations (A).
5. Cut damaged tine(s) so that it can be removed
from tube.
6. Remove bolts on existing tines and slide tines over to
replace tine that was cut off in previous step. Remove
reel arms (B) from tube as required.

Installing Steel Tines

WARNING
To avoid bodily injury from fall of raised reel, always engage reel safety props before going under raised
reel for any reason.
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
1. Slide new tines and reel arm (A) onto end of tube.
2. Install tine tube bushings. Refer to
Bushings, page 194.
3. Attach tines to tine bar with bolts and nuts (B).

Removing Plastic Fingers

WARNING
To avoid bodily injury from fall of raised reel, always engage reel safety props before going under raised
reel for any reason.
147725
MAINTENANCE AND SERVICING
Figure 5.152: Reel Arm
5.8.5 Tine Tube
Figure 5.153: Tine Tube
192
Revision A