Removing Plastic Fingers - MacDon D65 Operator's Manual

IMPORTANT:
Ensure the tine tube is supported at all times to prevent damage to the tube and other components.
1. Remove the applicable tine. For instructions, refer to
Removing Steel Tines, page
2. Slide the new tines and reel arm (A) onto the end of
the tube.
3. Install the tine tube bushings. For instructions, refer to
Installing Bushings on Five-, Six-, or Nine-Bat Reels, page
216.
4. Attach the tines to the reel tine tube with bolts and
nuts (B).

Removing Plastic Fingers

Plastic reel fingers are secured to the tine tube with a single Torx
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
1. Remove screw (A) using a Torx
214327
MAINTENANCE AND SERVICING
208.
® Plus 27 IP socket wrench.
B
Figure 5.166: Reel Tine Tube
® screw.
Figure 5.167: Removing Plastic Fingers
209
A
A
Revision B