Detaching And Storing Tow-Bar - MacDon Draper D65 Installation Instructions Manual

3.18 Detaching and Storing Tow-Bar

To detach and store the tow-bar, follow these steps:
1. Disconnect wiring connector (A) at front wheel.
2. Remove clevis pin (A).
3. Push latch (B) and lift tow-bar (C) from hook. Release
latch (B) and replace clevis pin (A).
4. Disconnect wiring connector (A) on tow-bar.
5. Remove pin (B) from inner end of header section then lift
inner end of towing vehicle section (C) out of inner end of
header section (D) to disassemble.
169784
INSTALLATION INSTRUCTIONS
Figure 3.104: Electrical Connection at Front Wheel
Figure 3.105: Outer End of Header Section
Figure 3.106: Tow-Bar Inner Ends
63
A
B A
C
D
A
B
C
Revision H