Table of Contents
Advertisement
3
Features and Functions
Trigger Output Signal
A "trigger out" signal is provided on the rear-panel Trig Out connector (used with
sweep and burst only). When enabled, a TTL-compatible square waveform with
either a rising edge (default) or falling edge is output from the rear-panel Trig Out
connector at the beginning of the sweep or burst.
– When the Internal (immediate) trigger source is selected, the function
– When the External trigger source is selected, the function generator
– When the Bus (software) or manual trigger source is selected, the function
– Front-Panel Operation: After enabling sweeps or burst, press the Trigger
– Remote Interface Operation:
126
Ext Trig
generator outputs a square waveform with a 50% duty cycle from the Trig Out
connector at the beginning of the sweep or burst. The period of the waveform
is equal to the specified sweep time or burst period.
automatically disables the "trigger out" signal. The Trig Out connector cannot
be used for both operations at the same time (an externally-triggered
waveform uses the same connector to trigger the sweep or burst).
generator outputs a pulse (>1 µs pulse width) from the
Trig Out connector at the beginning of each sweep or burst.
Setup softkey. Then select the desired edge by pressing the Trig Out softkey.
OUTPut:TRIGger:SLOPe {POSitive|NEGative}
OUTPut:TRIGger {OFF|ON}
OUTPUT
+3 V
>1 µs
0 V
Rising edge shown.
Keysight 33210A User's Guide
Advertisement
Table of Contents
