Table of Contents
Advertisement
4
Remote Interface Reference
The Standard Event Register
The Standard Event register group reports the following types of events: power-on
detected, command syntax errors, command execution errors, self-test or
calibration errors, query errors, or the *OPC command has been executed. Any or
all of these conditions can be reported to the Standard Event summary bit
through the enable register. To set the enable register mask, you must write a
decimal value to the register using the *ESE command.
Bit Definitions – Standard Event Register
Bit Number
0 Operation Complete
1 Not Used
2 Query Error
3 Device Error
4 Execution Error
5 Command Error
6 Not Used
7 Power On
276
Decimal
Definition
Value
1
All commands prior to and including *OPC have
completed and the overlapped command (e.g., *TRG for
burst) has completed.
2
Not Used. Returns "0".
4
The instrument tried to read the output buffer but it was
empty. Or, a new command line was received before a
previous query has been read. Or, both the input and
output buffers are full.
8
A self-test, cal, or other device-specific error has
occurred (see
16
An execution error has occurred (see
32
A command syntax error has occurred (see
64
Not Used. Returns "0".
128
Power has been cycled on since the last time the event
register was read or cleared.
Chapter
5).
Chapter
Keysight 33210A User's Guide
5).
Chapter
5).
Advertisement
Table of Contents
