Table of Contents
Advertisement
Triggering
Applies to sweep and burst only. You can issue triggers for sweeps or bursts using
internal triggering, external triggering, or manual triggering.
– Internal or "automatic" triggering is enabled when you turn on the function
– External triggering uses the rear-panel Trig In connector to control the sweep
– Manual triggering initiates one sweep or outputs one burst each time you
– The
Trigger Source Choices
Applies to sweep and burst only. You must specify the source from which the
function generator will accept a trigger.
– Sweep trigger source: Internal, External, or Manual. The default is Internal.
– The function generator will accept a manual trigger, a hardware trigger from
Keysight 33210A User's Guide
generator. In this mode, the function generator outputs continuously when the
sweep or burst mode is selected.
or burst. The function generator initiates one sweep or outputs one burst each
time Trig In receives a TTL pulse. You can select whether the function
generator triggers on the rising or falling edge of the external trigger signal.
press
from the front-panel. Continue pressing this key to
re-trigger the function generator.
key is disabled when in remote and when a function other than burst
or sweep is currently selected.
the rear-panel Trig In connector, or continuously output sweeps or bursts
using an internal trigger. At power-on, internal trigger is selected.
Features and Functions
3
121
Advertisement
Table of Contents
