Table of Contents
Advertisement
Waveform Frequency
The waveform frequency defines the repetition rate of the burst waveform in the
triggered and external gated modes. In the triggered mode, the number of cycles
specified by the burst count is output at the waveform frequency. In the external
gated mode, the waveform frequency is output when the external gate signal is
true.
Keep in mind that the waveform frequency is different than the "burst period"
which specifies the interval between bursts (triggered mode only).
– Waveform frequency: 1 mHz to 10 MHz (limited to 100 kHz for ramp
– For sine and square waveforms, frequencies above 3 MHz are allowed only
– Front-Panel Operation: To set the waveform frequency, press the Freq softkey
– Remote Interface Operation:
Keysight 33210A User's Guide
waveforms). The default waveform frequency is 1 kHz. (For an internally
triggered burst waveform, the minimum frequency is 2.001 mHz.) You can
select a sine, square, or ramp waveform (pulse, noise, dc, and arbitrary
waveforms are not allowed).
with an "infinite" burst count.
for the selected function. Then use the knob or numeric keypad to enter the
desired frequency.
FREQuency {<frequency>|MINimum|MAXimum}
You can also use the APPLy command to select the function, frequency,
amplitude, and offset with a single command.
Features and Functions
3
115
Advertisement
Table of Contents
