Keysight Technologies 33210A User Manual page 264

4 Remote Interface Reference
SYSTem:COMMunicate:LAN:NETBios {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:NETBios?
Disables or enables the use of NETBios to automatically assign an IP address to
the 33210A for peer-to-peer naming on a private network that uses the NETBios
naming service. The factory setting is enabled (ON). The query returns "0" (OFF) or
"1" (ON).
– If you change the NETBios setting, you must cycle power on the instrument to
– The NETBios setting is stored in non-volatile memory, and does not change
SYSTem:COMMunicate:LAN:TELNet:PROMpt <string>
SYSTem:COMMunicate:LAN:TELNet:PROMpt?
Sets the command prompt seen when using a Telnet session to communicate with
the 33210A. The default prompt is "33210A>".
– The 33210A uses LAN port 5024 for Telnet sessions.
– Telnet session can typically be started as follows from a host computer shell:
– For example:
– The prompt is a quoted string of up to 15 characters.
– The command prompt is stored in non-volatile memory, and does not change
264
activate the new setting.
when power has been off, or after an instrument reset (*RST).
telnet <IP_address> <port>
telnet 169.254.2.20 5024
To exit a Telnet session, press <Cntr-D>.
when power has been off, or after an instrument reset (*RST).
Keysight 33210A User's Guide