Keysight Technologies 33210A User Manual page 314

5 Error Messages
-222
Data out of range;
amplitude; value clipped to ...
This generic message indicates that the waveform amplitude has been limited to
an upper or lower boundary.
-222
Data out of range;
offset; value clipped to ...
This generic message indicates that the offset voltage has been limited to an
upper or lower boundary.
-222
Data out of range;
frequency in burst mode; value clipped to ...
This generic message indicates that the frequency has been limited to an upper or
lower boundary as dictated by the burst period.
-222
Data out of range;
frequency in FM; value clipped to ...
This generic message indicates that the carrier frequency has been limited to a
lower boundary as determined by the FM:DEV command. The carrier frequency
must always be greater than or equal to the frequency deviation.
-222
Data out of range;
marker confined to sweep span; value clipped to ...
This generic message indicates that the specified marker frequency is outside the
range of the start frequency and stop frequency. The marker frequency must be
between the specified start frequency and stop frequency. If you attempt to set
the marker frequency to a frequency not in this range, the function generator will
automatically set the marker frequency equal to the start frequency or stop
frequency (whichever is closer). This error is generated only when both the sweep
mode and the marker frequency are enabled.
314 Keysight 33210A User's Guide