Table of Contents
Advertisement
3
Features and Functions
Burst Count
The burst count defines the number of cycles to be output per burst.
Used in the triggered burst mode only (internal or external source)
– Burst count: 1 to 50,000 cycles, in 1 cycle increments. You can also select an
– When the Internal trigger source is selected, the specified number of cycles is
– When the Internal trigger source is selected, the burst count must be less than
– The function generator will automatically increase the burst period up to its
– When the gated burst mode is selected, the burst count is ignored. However, if
– Front-Panel Operation: To set the burst count, press the #Cycles softkey and
– Remote Interface Operation:
116
infinite burst count. The default is 1 cycle.
output continuously at a rate determined by the burst period setting. The burst
period defines the interval between bursts.
the product of the burst period and the waveform frequency as shown below.
Burst Count < Burst Period × Waveform Frequency
maximum value to accommodate the specified burst count (but the waveform
frequency will not be changed).
you change the burst count from the remote interface while in the gated mode,
the function generator remembers the new count and will use it when the
triggered mode is selected.
then use the knob or numeric keypad to enter the count. To select an infinite
count burst instead, press the #Cycles softkey again to toggle to the Infinite
softkey (press
BURSt:NCYCles {<# cycles>|INFinity|MINimum|MAXimum}
once to start the waveform, and a second time to stop it).
Keysight 33210A User's Guide
Advertisement
Table of Contents
