Keysight Technologies 33210A User Manual page 56

2 Front-Panel Menu Operation
4 Set the burst period.
5 View the waveform.
You can generate a single burst (with the specified count) by pressing the
NOTE
key. For more information, see
You can also use an external gate signal to either turn the burst signal "on" or
"off" based on the external signal applied to the rear-panel Trig In connector. For
more information see
56
Press the Burst Period softkey and then set the period to 20 ms using the
numeric keypad or the knob and cursor keys. The burst period sets the time
from the start of one burst to the start of the next burst (note the display icon).
At this point, the function generator outputs a continuous three-cycle burst (if
the output is enabled).
Press to view the waveform parameters.
To turn off the Graph Mode, press
"Burst Mode"
again.
"To Trigger a Sweep or Burst"
on page 112.
on page 57.
Keysight 33210A User's Guide