Table of Contents
Advertisement
3
Features and Functions
Display Control
For security reasons, or to speed up the rate at which the function generator can
execute commands from the remote interface, you may want to turn off the
front-panel display. From the remote interface, you can also display a
12-character message on the front panel.
– You can only disable the front-panel display by sending a command from the
– When disabled, the front-panel display is blanked (however, the bulb used to
– Sending a message to the front-panel display from the remote interface
– The display is automatically enabled when power is cycled, after an instrument
– The display state is saved when you store the instrument state using *SAV
– You can display a text message on the front panel by sending a command from
140
remote interface (you cannot disable the front panel while in local operation).
backlight the display remains enabled). All keys except
when the display is disabled.
overrides the display state. This means that you can display a message even if
the display is currently disabled (remote interface errors are always displayed
even if the display is disabled).
reset (*RST command), or when you return to local (front panel) operation.
Press the
key or execute the IEEE-488 GTL (Go To Local) command
from the remote interface to return to the local state.
command. When you recall the instrument state using *RCL command, the
front-panel display will return to the previous state.
the remote interface. You can use upper- or lower-case letters (A-Z), numbers
(0-9), and any other character on a standard computer keyboard. Depending
on the number of characters that you specify, the function generator will
choose one of two font sizes to display the message. You can display
approximately 12 characters in a large font and approximately 40 characters in
a small font.
are locked out
Keysight 33210A User's Guide
Advertisement
Table of Contents
