Keysight Technologies 33210A User Manual page 210

4 Remote Interface Reference
AM:STATe {OFF|ON}
AM:STATe?
Disable or enable AM. To avoid multiple waveform changes, you can enable AM
after you have set up the other modulation parameters. The default is OFF.
The :STAT? query returns "0" (OFF) or "1" (ON).
– The function generator will allow only one modulation mode to be enabled at a
– The function generator will not allow AM to be enabled at the same time that
210
time. For example, you cannot enable AM and FM at the same time. When you
enable AM, the previous modulation mode is turned off.
sweep or burst is enabled. When you enable AM, the sweep or burst mode is
turned off.
Keysight 33210A User's Guide