5
Error Messages
Arbitrary Waveform Errors
The following errors indicate failures that may occur during arbitrary waveform
operation. Refer to
more information.
770
Nonvolatile arb waveform memory corruption detected
The non-volatile memory used to store arbitrary waveforms has detected a
checksum error. The arbitrary waveform cannot be retrieved from memory.
781
Not enough memory to store new arb waveform; use DATA:DELETE
The four non-volatile memory locations already contain arbitrary waveforms. To
store another waveform, you must first delete one of the stored waveforms using
the DATA:DELete command.
781
Not enough memory to store new arb waveform; bad sectors
Due to a hardware error, there are no more memory locations available to store
arbitrary waveforms. This error is likely the result of a failed Flash memory device.
782
Cannot overwrite a built-in waveform
The following built-in waveform names are reserved and cannot be used with the
DATA:COPY command: "EXP_RISE", "EXP_FALL", "NEG_RAMP", "SINC", and
"CARDIAC".
784
Name of source arb waveform for copy must be VOLATILE
When using the DATA:COPY command, you cannot copy from any source other than
"VOLATILE".
326
"Arbitrary Waveform Commands (Option 002)"
on page 240 for
Keysight 33210A User's Guide