Keysight Technologies 33210A User Manual page 198

4 Remote Interface Reference
FUNCtion:RAMP:SYMMetry {<percent>|MINimum|MAXimum}
FUNCtion:RAMP:SYMMetry? [MINimum|MAXimum]
Set the symmetry percentage for ramp waves. Symmetry represents the amount
of time per cycle that the ramp wave is rising (assuming that the waveform
polarity is not inverted). You can set the symmetry to any value from 0% to 100%.
The default is 100%. MIN = 0%. MAX = 100%. The :SYMM? query returns the
current symmetry setting in percent.
– For ramp waveforms, the APPLy command overrides the current symmetry
– The symmetry setting is remembered when you change from ramp wave to
– If you select a ramp waveform as the modulating waveform for AM or FM, the
OUTPut {OFF|ON}
OUTPut?
Disable or enable the front-panel Output connector. The default is "OFF". When the
output is enabled, the
panel. The OUTP? query returns "0" (OFF) or "1" (ON).
– The APPLy command overrides the current OUTP command setting and
– If an excessive external voltage is applied to the front-panel Output connector,
198
0% Symmetry 100% Symmetry
setting and automatically selects 100%.
another function. When you return to the ramp wave function, the previous
symmetry is used.
symmetry setting does not apply.
automatically enables the Output connector ("ON").
an error message will be displayed and the output will be disabled.
To re-enable the output, remove the overload from the Output connector and
send the OUTP ON command.
key is illuminated on the function generator's front
Keysight 33210A User's Guide