Table of Contents
Advertisement
APPLy Command Syntax
– Because of the use of optional parameters in the APPLy commands (enclosed
– You can substitute "MINimum", "MAXimum", or "DEFault" in place of specific
– The APPLy command performs the following operations:
Keysight 33210A User's Guide
in square brackets), you must specify frequency to use the amplitude
parameter, and you must specify both frequency and amplitude to use the
offset parameter. For example, the following command string is valid
(frequency and amplitude are specified but offset is omitted and therefore uses
a default value).
APPL:SIN 5.0E+3, 3.0
However, you cannot specify an amplitude or offset without specifying a
frequency.
values for the frequency, amplitude, and offset parameters. For example, the
following statement outputs a 3 Vpp sine wave at 10 MHz (the maximum
frequency for sine) with a -2.5 volt offset.
APPL:SIN MAX, 3.0, -2.5
– Sets the trigger source to Immediate (equivalent to sending the TRIG:SOUR
IMM command).
– Turns off any modulation, sweep, or burst mode currently enabled and
places the instrument in the continuous waveform mode.
– Turns on the Output connector (OUTP ON command) but does not change
the output termination setting (OUTP:LOAD command).
– Overrides the voltage autorange setting and automatically enables
autoranging (VOLT:RANG:AUTO command).
– For square waveforms, overrides the current duty cycle setting and
automatically selects 50% (FUNC:SQU:DCYC command).
– For ramp waveforms, overrides the current symmetry setting and
automatically selects 100% (FUNC:RAMP:SYMM command).
Remote Interface Reference
4
185
Advertisement
Table of Contents
