Table of Contents
Advertisement
12 | Keysight | Sourcing Precise Current/Voltage Sinusoidal Waveforms Using the B2961A/62A – Demo Guide
10) Press
to save the changes.
You can now see the monitored output voltage waveform and the phase marker output signal on
the oscilloscope as shown below.
Oscilloscope waveforms
1-3. Monitor the entire output signal on its GUI
The default settings of the B2961A/62A make it monitor only the first waveform even if multiple
waveforms are configured on the instrument. However, you can modify the Trigger Parameters to
monitor the B2961A/62A's entire output and eliminate the need for an oscilloscope.
The following example shows how to modify the B2961A/62A's parameters to capture the entire
waveform in Graph View.
1) Press
repeatedly until the Single View for Channel 1 is shown on the display.
2) Press
to toggle the displayed Assist keys, and then press
Trigger Sub-Panel.
Channel
output signal
Phase marker
output from
the Digital I/O
to display the
Advertisement
Table of Contents
