Table of Contents
Advertisement
Burst Trigger Source
In the triggered burst mode, the function generator outputs a burst with the
specified number of cycles (burst count) each time a trigger is received. After the
specified number of cycles have been output, the function generator stops and
waits for the next trigger. At power-on, the internally-triggered burst mode is
enabled.
– Burst trigger source: Internal, External, or Manual. The default is Internal.
– When the Internal (immediate) source is selected, the frequency at which the
– When the External source is selected, the function generator will accept a
– When the Manual source is selected, the function generator outputs one burst
– When the External or Manual trigger source is selected, the burst count and
– Front-Panel Operation: Press the Trigger Setup softkey and then select the
– Remote Interface Operation:
Keysight 33210A User's Guide
burst is generated is determined by the burst period.
hardware trigger applied to the rear-panel Trig In connector. The function
generator outputs the specified number of cycles each time Trig In receives a
TTL pulse with the specified polarity. External trigger signals that occur during
a burst are ignored.
each time the front-panel
burst phase remain in effect but the burst period is ignored.
desired source by pressing the Source softkey.
To specify whether the function generator triggers on the rising or falling edge
of the signal on the Trig In connector, press the Trigger Setup softkey. Then
select the desired edge by pressing the Slope softkey.
TRIGger:SOURce {IMMediate|EXTernal|BUS}
Use the following command to specify whether the function generator triggers
on the rising or falling edge of the Trig In connector.
TRGger:SLOPe {POSitive|NEGative}
See
"Triggering"
on page 121 for more information on triggering.
Features and Functions
key is pressed.
3
119
Advertisement
Table of Contents
