Keysight Technologies 33210A User Manual page 262

4 Remote Interface Reference
GPIB Interface Commands:
SYSTem:COMMunicate:GPIB:ADDRess <address>
SYSTem:COMMunicate:GPIB:ADDRess?
Sets the GPIB (IEEE-488) address for the 33210A. The GPIB address can take any
value between 0 and 30. The factory default is 10.
LAN Interface Commands:
SYSTem:COMMunicate:LAN:AUTOip[:STATe] {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:AUTOip[:STATe]?
Disables or enables use of the Auto-IP standard to automatically assign an IP
address to the 33210A. The factory setting is enabled (ON). The query returns "0"
(OFF) or "1" (ON).
– If you change the Auto-IP setting, you must cycle power on the instrument to
– Auto-IP allocates IP addresses from the link-local address range
– The Auto-IP setting is stored in non-volatile memory, and does not change
SYSTem:COMMunicate:LAN:IPADdress <address>
SYSTem:COMMunicate:LAN:IPADdress?
Assigns a static Internet Protocol (IP) address for the 33210A, which is used if
DHCP or Auto-IP cannot assign an IP address. The factory setting is
"169.254.2.20". See your network administrator for a valid IP address to use. The
query returns the current static IP address.
– If you change the IP address setting, you must cycle power on the instrument
– The IP address is stored in non-volatile memory, and does not change when
262
activate the new setting.
(169.254.xxx.xxx).
when power has been off, or after an instrument reset (*RST).
to activate the new setting.
power has been off, or after an instrument reset (*RST).
Keysight 33210A User's Guide