Keysight Technologies 33210A User Manual page 61

To set a password use the knob and cursor keys (use
NOTE
characters to the right of the cursor position). The Web Server Interface will
prompt for the password to protect certain windows. See
Interface"
3 Establish an "IP Setup."
Keysight 33210A User's Guide
From this menu, you can select Reset LAN to restart the LAN, IP Setup to set
an IP address and related parameters, DNS Setup to configure DNS, or
Password to set a password for the Web Server Interface.
page 152, for further information.
To use the Keysight 33210A on the network, you must first establish an IP
setup, including an IP address, and possibly a subnet mask and gateway
address. Press the IP Setup softkey. By default, both DHCP and Auto IP are set
to On.
With DHCP On, an IP address will automatically be set by DHCP (Dynamic
Host Configuration Protocol) when you connect the Keysight 33210A to the
network, provided the DHCP server is found and is able to do so. DHCP also
automatically deals with the subnet mask and gateway address, if required.
This is typically the easiest way to establish LAN communication for your
instrument. All you need to do is leave DHCP On.
With Auto IP On, if DHCP fails to assign an IP address, Auto IP will attempt to
do so after a time-out period.
However, if you cannot establish communication by means of DHCP or Auto IP,
you will need to manually set an IP address, and a subnet mask and gateway
address if they are in use. Follow these steps:
a Set the "IP Address." Press the softkeys to select DHCP Off and Auto IP
Off. The manual selection softkeys appear and the current IP address is
Front-Panel Menu Operation
to delete all
"Keysight 33210A Web
2
61