Keysight Technologies 33210A User Manual page 72

3 Features and Functions
– You can set the output amplitude in Vpp, Vrms, or dBm. For more information,
– You cannot specify the output amplitude in dBm if the output termination is
– Arbitrary Waveform Limitations: For arbitrary waveforms, the maximum
– While changing amplitude, you may notice a momentary disruption in the
– You can also set the amplitude (with an associated offset voltage)
– For dc volts, the output level is actually controlled by setting the offset
– Front-Panel Operation: To set the output amplitude, press the Ampl softkey for
72
see "Output Units" on page 75.
currently set to "high impedance". The units are automatically converted to
Vpp. For more information, see
amplitude will be limited if the waveform data points do not span the full range
of the output DAC (Digital- to-Analog Converter). For example, the built-in "Sinc"
waveform does not use the full range of values between ±1 and therefore its
maximum amplitude is limited to 6.087 Vpp (into 50 ohms).
output waveform at certain voltages due to switching of the output
attenuators. To prevent this disruption in the output, you can disable the
voltage autoranging feature as described on page 79.
by specifying a high level and low level. For example, if you set the high level to
+2 volts and the low level to -3 volts, the resulting amplitude is 5 Vpp (with an
offset voltage of -500 mV).
voltage. You can set the dc level to any value between ±5 Vdc into 50 ohms or
±10 Vdc into an open circuit. See
more information.
To select dc volts from the front panel, press
softkey. Press the Offset softkey to set the desired offset voltage level.
the selected function. Then use the knob or numeric keypad to enter the
desired amplitude. To set the amplitude using a high level and low level, press
the Ampl softkey again to toggle to the HiLevel and LoLevel softkeys.
"Output Units" on page 75.
"DC Offset Voltage"
and then select the DC On
Keysight 33210A User's Guide
on the following page for