Table of Contents
Advertisement
3
Features and Functions
Sweep Mode
You can sweep with either linear or logarithmic spacing. For a linear sweep, the
function generator varies the output frequency in a linear fashion during the
sweep. For a logarithmic sweep, the function generator varies the output
frequency in a logarithmic fashion.
– Sweep mode: Linear or Logarithmic. The default is Linear.
– Front-Panel Operation: After enabling sweeps, press the Linear softkey again
– Remote Interface Operation:
Sweep Time
The sweep time specifies the number of seconds required to sweep from the start
frequency to the stop frequency. The number of discrete frequency points in the
sweep is automatically calculated by the function generator and is based on
the sweep time you select.
– Sweep time: 1 ms to 500 seconds. The default is 1 second.
– Front-Panel Operation: After enabling sweeps, press the Sweep Time softkey.
– Remote Interface Operation:
108
to toggle between the linear or log mode.
SWEep:SPACing {LINear|LOGarithmic}
Then use the knob or numeric keypad to enter the desired sweep time.
SWEep:TIME {<seconds>|MINimum|MAXimum}
Keysight 33210A User's Guide
Advertisement
Table of Contents
