Generating A Sweep Signal - Keysight Technologies N9310A Quick Start Manual

Generating a Sweep Signal

Setting up a Step Sweep
To simplify the example, assume you wish to generate a RF
sweep signal with the characteristics of:
• Frequency range from 1 to 2 GHz
• Step sweep of 10 points
• Dwell time of 500 ms for each step
Operation
1. Press hardkey
Preset
2. Press hardkey
Sweep
3. Press Step Sweep softkey
4. Press RF Start > 1 > GHz
5. Press RF Stop > 2 > GHz
6. Press #Points > 10 > Enter
7. Press
More>Step Dwell>500>ms
Quick Start Guide
Generating a Sweep Signal
Notes
Sets the signal generator to its
factory-defined instrument state.
Enables the submenu of sweep
softkeys.
Enables the submenu of sweep
settings.
Sets the step sweep start
frequency to 1 GHz.
Sets the step sweep stop
frequency to 2 GHz.
Sets the step point to 10 in the step
sweep.
Sets the dwell time to 500 ms for
each point in the step sweep.
11