Operation Of Dmac (Repeated Transfer Mode) - Renesas M16C Series User Manual

M30245 Group

2.10.3 Operation of DMAC (repeated transfer mode)

In repeat transfer mode, choose functions from the items shown in Table 2.10.2. Operations of the circled
items are described below. Figure 2.10.7 shows an example of operation and Figure 2.10.8 shows the
set-up procedure.
www.DataSheet4U.com
Operation
BCLK
Address bus
RD signal
WR signal
Data bus
Write signal to
software DMAi
request bit
DMAi
request bit
DMA transfer
counter
DMAi
interrupt
request bit
"1"
DMAi
enable bit
• In the case in which the number of transfer times is set to 2.
Figure 2.10.7. Example of operation of repeated transfer mode
Rev.2.00 Oct 16, 2006
REJ09B0340-0200
Table 2.10.2. Choosed functions
Item
Transfer space Fixed address from an arbitrary 1 M bytes space
Arbitrary 1 M bytes space from a fixed address
O
Fixed address from fixed address
Unit of transfer
8 bits
16 bits
O
(1) When software trigger is selected, setting software DMA request bit to "1" generates a DMA
transfer request signal.
(2) If DMAC is active, data transfer starts, and the contents of the address indicated by the DMAi
forward-direction address pointer are transferred to the address indicated by the DMAi desti-
nation pointer. When data transfer starts directly after DMAC becomes active, the value of
the DMAi transfer counter reload register is reloaded to the DMAi transfer counter, and the
value of the DMAi source pointer is reloaded by the DMAi forward-direction address pointer.
Each time a DMA transfer request signal is generated, 2 byte of data is transferred. The
DMAi transfer counter is down counted, and the DMAi forward-direction address pointer is up
counted.
(3) Though DMAi transfer counter is underflowed, DMA enable bit is still "1". The DMA interrupt
request bit changes to "1" simultaneously.
(4) After DMAi transfer counter is underflowed, when the next DMA request is generated, DMA
transfer is repeated from (1).
(1) Request signal for a DMA transfer occurs
(2) Data transfer begins
Destination Dummy cycle
CPU use
Source
Destination
CPU use Source
01
16
Indeterminate
page 247 of 354
(3) Underflow
Destination
CPU use Source
Destination
Dummy cycle
CPU use Source
00
16
Cleared to "0" when interrupt request is accepted, or cleared by software
Set-up
Dummy cycle Destination
CPU use Source
Dummy cycle Destination
CPU use Source
FF
16
2. DMAC
Dummy cycle
CPU use
Dummy cycle
CPU use
01
16
00
16