Cautions In Programming - Samsung OfficeServ 500 Programming Manual

1.3 Cautions in Programming

Programming can be done while the handset is placed on the phone at a idle state.
Programming can be done on any phone.
Programming can be done only on the phone, not on normal phone.
If the phone does not have the LCD display, press the numbers using the dial buttons
as instructed by the programming guide, without using the volume buttons. However,
if the phone does not have Soft buttons, certain programming cannot be done.
Therefore, only the station level programming is allowed on the phone that does not
have the LCD display.
If the LCD displays an 'INVALID DATA' message while programming, this means
that the entered data is invalid. Enter the correct data again.
The content of the displayed message for each step shows the status after each step is
executed.
If no key is pressed for a certain period of time during programming(Key program end
time, default is 60 seconds), it becomes a idle state from programming mode.
If the phone is off hook while programming, it becomes a dial state from programming
mode.
Before the modified data is confirmed by pressing [Left Soft] button or [Right Soft]
button, the [Speaker] or [Transfer] button is pressed to make it at a idle state or the
phone is unplugged. In this case, the data entered up to that time will be automatically
saved as the data displayed on the LCD.
© SAMSUNG Electronics Co., Ltd.
OfficeServ 500 Programming Guide
1-5