Table of Contents
Advertisement
SYSTEM ADMINISTRATOR
PROGRAMMING
CUSTOMER LEVEL ACCESS
Before any customer programs can be accessed, you must first open system
programming using the passcode you have been assigned. You must use an
LCD 12B or LCD 24B keyset. Should it become necessary to change this
passcode, see your service company.
•
While on-hook, press TRSF and then dial 200. Your display shows [EN-
ABLE CUS. PROG. PASSCODE].
•
Dial the four digit passcode. The display shows [ENABLE CUS. PROG. -
DISABLE].
•
Dial 1 to enable. The display shows [ENABLE CUS. PROG - ENABLE].
•
Press TRSF. The keyset returns to its idle condition.
•
Press TRSF and then dial the three digit program code you want to ac-
cess. Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in pro-
gramming, any delay of more than 30 seconds between key strokes will cause
the system to automatically close programming.
9
Advertisement
Table of Contents
