Ethernet Parameters - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[830] ETHERNET PARAMETERS

This MMC provides a mean to configure the Internet Protocol(IP) addressing of the
OfficeServ 500 system MCP2 card. This MMC must be utilized if there are ITP series
phones and/or MGI cards used on the system. System only allow to connected by other
system(CTI Server, News Server), when CTI SERVER ADDR, NEWS ADDRESS is not
set such as 0.0.0.0 or 255.255.255.255.
No Parameter
00 SYSTEM IP ADDR
01 SYSTEM GATEWAY
02 SYSTEM NET MASK
03 SYSTEM RESET
04 SYSTEM IP TYPE
05 SYSTEM PUBLIC IP
06 SYSTEM MAC ADDR
07 PCMMC ADDRESS
08 SM MANAGER IP
2-360
Specifies the IP address for the MCP2 card.
Specifies the designated gateway IP address used for contacting
IP devices beyond the local network subnet.
Specifies the IP subnet mask.
This parameter is used by the system to calculate the range of IP
devices(subnet) that are within 'direct reach' of the MCP2(without
having to go through the designated network IP gateway).
Prompt to restart system MCP2 when system IP address is
changed. This reset is same to FAST RESTART on MMC 811.
Defines which IP addressing relationship is used for
communications to and from the MCP2 card.
0 PRIVATE IP ONLY: The system assumes all IP phones and
VoIP connections are on the same network. And all IP
addresses are private IP address.
1 PRIVATE w PUBLIC: The system knows that there is a mixture
of IP phones and VoIP connections on the same network and
on remote network(s), thus communicates accordingly based
upon the entries in MMC 840(for IP phones), MMC 838(for
other VoIP gateways) or MMC 830(for other MCP2).
2 PUBLIC IP ONLY: The system assumes all IP phones and VoIP
connections are on the different public network. And all IP
addresses are public IP address.
The MCP2 will originate communications, to IP phones and VoIP
connections outside the local network, using this IP address.
Communications to/from this IP will require involvement of the MGI
card. The system identifies communications to/from this address
as 'public'. This allows devices, on remote networks/subnets, to
establish communications with the system, without exposing your
LAN. See 'SYSTEM IP TYPE'.
For your reference, and cannot be changed. The unique hardware
(MAC) address of the MCP2 card.
When system wants connect to PCMMC, system will be sent to
this IP address for connection message. Reserved for future use.
When system wants connect to remote M & A PC, system will be sent
to this IP address for connection message. Reserved for future use.
Description
© SAMSUNG Electronics Co., Ltd.