Samsung OfficeServ 500 Programming Manual page 186

CHAPTER 2. Ошибка! Стиль не определен.
No Option
6 CLIR w NUMB
CONDITIONS
Before setting the PRI program, the J2 jumper of the TEPRI board must be set to 'ON'
for PRI mode.
After changing this program, execute 'MMC 425 BRI AND PRI CARD RESTART' to
apply the new setting.
DEFAULT DATA
CHANNEL ANY: YES
PRI MODE: DDI
DLSEND: OVERLAP
CLIP TABLE: NONE
NB TYPE: UNKNOWN
NB PLAN: UNKNOWN
CLIR w NUMB: OFF
ACTION
1) Press Transfer button and enter 427.
Display shows:
2) Dial first PRI trunk number in PRI card.(e.g., 730)
OR
Press Volume button to make selection and
press Right Soft button.
3) Enter option number to make selection.
OR
Press Volume button to make selection.
4) Press Volume button to make selection.
Then press Right Soft button.
5) Press Transfer button and enter to exit.
OR
Press Speaker button to advance next MMC.
2-144
When this option is set to ON, the CLIP number is sent to the network
even though the CLIP restriction flag is set.
0. OFF
1. ON
Description
DISPLAY
[701] PRI OPTION
CHANNEL ANY:YES
[730] PRI OPTION
CHANNEL ANY:YES
[730] PRI OPTION
PRI MODE:DDI
[730] PRI OPTION
PRI MODE:NORMAL
© SAMSUNG Electronics Co., Ltd.
(Continued)