Bri And Pri Card Restart - Samsung OfficeServ 500 Programming Manual

Hide thumbs Also See for OfficeServ 500:

Table of Contents

[425] BRI AND PRI CARD RESTART

This MMC is used to restart a BRI and a PRI card at the card level. This action is required

to update the processor on the BRI and PRI card to any changes in the card setup MMC's

and to put these changes into effect.

A BRI card or TEPRI card must be installed in the system.

Before setting the PRI program, the J2 jumper of the TEPRI board must be set 'ON' to

DEFAULT DATA

1) Press Transfer button and enter 425.

Display shows first BRI or PRI circuit:

2) Dial first trunk on a BRI or PRI card.(e.g., 733)

Press Volume button to select the first trunk

and press Right Soft button to move the cursor.

3) Dial 1 for YES or Dial 0 for NO.

Pressing 1 will advance to step 4.

4) Dial 1 for YES or Dial 0 for NO.

Pressing 1 or 0 will return to step 2.

5) Press Transfer button and enter to exit.

Press Speaker button to advance next MMC.