Assign Trunk Signal - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[412] ASSIGN TRUNK SIGNAL

Allows for the assignment of analog DID or E & M cards for proper signaling.
This MMC is only for analog types of DID/E & M trunks. These trunks can also use the
translation tables in MMC 714. The signaling condition types are as follows:
No
0 IMMEDIATE START
1 DELAYED START
2 WINK START
CONDITIONS
An analog E & M/DID Trunk card must be installed in the OfficeServ 500 system.
Otherwise, the 'NO E & M/DID TRUNK' message is displayed.
DEFAULT DATA
IMMEDIATE
ACTION
1) Press Transfer button and enter 412.
Display shows:
2) Enter desired trunk number.(e.g., 705)
OR
Press Volume button to make selection and
press Right Soft button to move cursor.
OR
Press ANS/RLS button to select all trunks.
3) Enter desired trunk type selection from above list.
OR
Press Volume button to make selection and
press Right Soft button.
4) Press Transfer button and enter to exit.
OR
Press Speaker button to advance next MMC.
RELATED ITEMS
MMC 416
MMC 714
2-124
Signaling condition type
E & M/DID RINGDOWN
DID NUMBER AND NAME TRANSLATION
DISPLAY
[701] TRK SIGNAL
IMMEDIATE START
[705] TRK SIGNAL
IMMEDIATE START
[ALL] TRK SIGNAL
IMMEDIATE START
[705] TRK SIGNAL
WINK START
© SAMSUNG Electronics Co., Ltd.